GlueArt

Specifically designed to bond to acoustic foam and EPS

GlueArt 2.0 is a polymer-based glue, specifically designed to bond to acoustic foam and EPS. POP is a polymer with superior adhesive efficiency, with double the initial tack of the GlueArt 1.0. it presents higher durability, faster bonding, and is completely humidity-resistant. It is applicable on a vast range of surfaces, including cement, painted surfaces, stone, wallpaper, plasterboard, wood, chipboard, PVC, expanded plastic, mineral fibres and metal. It is also resistant from -40 to 90ºC.

GlueArt 2.0 is especially easy to use, gluing lighter panels such as Myron E practically instantly. Heavier panels, although requiring initial support, start to bond after just 10 minutes, bonding with a safety factor of over 10.

Installation Procedure:

1. The surface must be clean, dry, and free of grease.
2. Apply the adhesive to the back of the panel with a sealant gun. If applying to an extremely irregular surface, apply adhesive to both the panel and the target surface.
3. Place the panel on the wall in the correct position and apply pressure.

Install the panel within 10 minutes after applying the glue. Heavier panels require additional support until the adhesive has cured.
Avoid making any adjustments to the panel after gluing, as this may reduce the glue force. The cure time depends on the layer thickness, temperature, and air humidity.

  Each tube of glue installs either 8 flat foam panels (Agad, Thor, Myron E, etc.) or 8 nestled foam panels (framed absorbers). 

GlueArt 2.0 (Un.)
Box
Units per box: 1
Dimensions: 310x450x140mm
Volume: 0.02m3
Weight: 0.51Kg